DST Forum

Main Features:

• Editing all immobilizer data stored in the EEPROM and Powerclass in Flash.
  

Working with the Module

To begin, load the flash and EEPROM files .
During loading, the file sizes are checked to ensure they are valid. 
The module can also operate without a flash file if the MCU ID is known. In this case, enter it in the “MCU ID” field. The program will then recognize and process the MCU ID automatically.
After the data has been loaded successfully, you can begin working with the immobilizer data.
The following data can be modified: VIN, Immo ID, CS, MAC, PIN, Make, and PowerClass.
Immobilizer data can be edited manually or by copying values into the corresponding fields.
After making the required changes, save the data by clicking the “Save Files” button. The entered data is validated before it is saved.
Important Note:
To process the immobilizer data correctly, the flash and EEPROM files must come from the same ECU. Using files from different ECUs will result in incorrect data decryption.
Pay particular attention to the flash file: it must be a complete flash dump and not contain only calibration data.